ST STM32F0

Supported MCUs

The following list includes MCUs from STM32F0 series and indicates whether they are supported in NuttX

MCU Support Note

---

STM32F0x0 Yes Value line STM32F0x1 Yes Access line STM32F0x2 Yes USB line STM32F0x8 Yes Low-voltage line

Peripheral Support

The following list indicates peripherals supported in NuttX:

Peripheral Support Notes

---

FLASH CRC PM RCC CSR GPIO SYSCFG DMA EXTI ADC DAC COMP TSC TIM IRTIM IWDG WWDG RTC I2C USART SPI I2S CAN USB HDMI-CEC No No No Yes No Yes Yes Yes Yes Yes No No No Yes No Yes Yes No Yes Yes Yes No No Yes No

Flashing and Debugging

NuttX firmware Flashing with STLink probe and OpenOCD:

openocd -f  interface/stlink.cfg -f target/stm32f0x.cfg -c 'program nuttx.bin 0x08000000; reset run; exit'

Remote target Reset with STLink probe and OpenOCD:

openocd -f interface/stlink.cfg -f target/stm32f0x.cfg -c 'init; reset run; exit'

Remote target Debug with STLink probe and OpenOCD:

1. You need to have NuttX built with debug symbols, see debugging.

2. Launch the OpenOCD GDB server:

   openocd -f interface/stlink.cfg -f target/stm32f0x.cfg -c 'init; reset halt'
   

3. You can now attach to remote OpenOCD GDB server with your favorite debugger, for instance gdb:

   arm-none-eabi-gdb --tui nuttx -ex 'target extended-remote localhost:3333'
   (gdb) monitor reset halt
   (gdb) breakpoint nsh_main
   (gdb) continue
   

Supported Boards

boards//