ST STEVAL-ETH001V1

chip:stm32, chip:stm32f7, chip:stm32f767

This page discusses issues unique to NuttX configurations for the STMicro STEVAL-ETH001V1 servo drive evaluation board. The STEVAL-ETH001V1 board is based on the STM32F767ZI MCU (2Mbytes FLASH and 512Kbytes of SRAM).

The boards features:

• Three-phase motor driver inverter based on STDRIVE101 gate driver and STH270N8F7-2 power MOSFET
• NETX90 network controller
• Operating supply voltage up to 48 V with a max. overvoltage robustness of 60 V
• Motor brake dissipative energy circuit
• Digital actuation section for industrial loads
• RS485 interface for digital encoder and host interface